computer connector
Technological innovation is mainly concentrated in the following directions
1. Connector miniaturization development technology
This technology is mainly developed for the miniaturization trend of connectors, and can be applied to micro-miniature connectors below 0.3mm, which belongs to the new varieties of MINI USB series products. It can be used for multi-contact expansion card slot connectors, which can meet and exceed the strict requirements of multi-contact surface mount technology butt joint coplanarity, with high accuracy and low cost.
2. High frequency and high speed wireless transmission connector technology
This technology is mainly aimed at a variety of wireless device communication applications and has a wide range of applications.
3. Research on simulation application technology
Simulation technology is based on a variety of disciplines and theories, using computer and its corresponding software such as AutoCAD, Pro/E program stress analysis software as tools, through the establishment of product models and corresponding boundary conditions, to its mechanical, electrical, high-frequency Simulation analysis and confirmation of other performances are carried out, thereby reducing the cost of product development failure caused by factors such as material selection and unreasonable structure, improving the development success rate, and helping to provide support for the realization of complex system applications for products.
4. Connector intelligent technology
This technology is mainly used in DC series power connector products. Intelligent signal detection can be performed before power transmission to ensure that the positive and negative poles are turned on and the power is turned on after the plug is inserted in place. In the future, enterprises need to develop similar intelligent technologies for other products.
The main purpose of fiber optic connectors is to connect optical fibers. Optical fiber connectors, which have been widely used in optical fiber communication systems, have many types and different structures. But on closer inspection, the basic structure of various types of fiber optic connectors is the same, that is, most fiber optic connectors are generally realized by high-precision components (composed of two pins and a coupling tube). Alignment of optical fibers.
In this method, the optical fiber is inserted and fixed in the ferrule, and after the surface of the ferrule is polished, alignment is achieved in the coupling tube. The outer components of the pins are made of metal or non-metal materials.
The butt end of the ferrule must be ground, and the other end usually uses a bend limiting member to support the fiber or fiber optic cable to relieve stress.
The coupling tube is generally made of two semi-synthetic and fastened cylindrical members made of ceramic or bronze and other materials, and is often equipped with a metal or plastic flange to facilitate the installation and fixation of the connector. In order to align the fibers as precisely as possible, the processing precision of the pins and coupling tubes is very high.
Read recommendations:
Probe connector M709pogopin pogopin connector Thimble connector magnetic pogo pin connector Through
Copper spring terminal M0951.9X6.0 pogopin factory Bending needle series price
Spring probe M133 3X7.5pogopin factory!Probe connector company
What factors should be considered in the design of pogopin connector?
Factors that need to be considered in the design of pogo pin spring thimble