1. Lathe processing technology of POGO PIN connector
POGO PIN connectors should be processed with Japanese automatic lathes, so that the precision of the parts can be guaranteed within +/-0.01mm to prevent excessive dimensional errors. In our complete high-end POGO PIN processing and production process (Figure 1)
Don't worry about these problems, because we not only have automatic lathe processing, we also have a strict quality department to check each POGO PIN, not only that, we will also conduct random inspection of POGO PIN finished products, and POGO PIN connectors will be shipped. We also have shipment inspection. The surface finish of lathe machining, especially the inner surface finish of POGO PIN needles, is very critical. Most factories do not have surface roughness testing equipment, and there is no parameter to supervise this. We have our own production parameters. There are scratches, knife marks, and curling on the inner surface of our POGO PIN. These are all of poor quality. We always Put quality first in our POGO PIN production. In terms of price, the price is relatively slightly lower than that of the peers, because the advanced nature of our technology has greatly reduced the consumables of defective products, thereby saving costs.
Second, the electroplating process of POGO PIN connector
The thickness of the plating layer has a huge impact on the cost structure. The gold plating of our POGO PIN starts from 5u”. Secondly, the quality of the gold plating in the hole has a great influence on the electrical performance (impedance) and mechanical performance of the pin. We always adhere to the industry-leading level. Supplier cooperation, strict supplier selection standards and processes and IQC control process ensure that the gold plating layer in the hole is good, without blackening, discoloration and poor plating. The electroplating process calculates the cost according to the thickness required by the customer.
3. Assembly process of POGO PIN connector
Poor assembly process can cause the needle to be skewed, the gap between the height and the length of the needle is too large, the pin is stuck, the nozzle is peeled, and other serious problems. We have our own assembly department. Once the problem is found, we will find the source and fundamentally eliminate the quality problem of POGO PIN. Not only that, but having your own assembly department can also facilitate the management of products and reduce time-consuming, so as to achieve the effect of high quality and low price.